Renovation & Remodelingin Salt Lake Sector I
Renovation & Remodeling in Salt Lake Sector I is something we get asked for a lot, and the honest reason is that Salt Lake Sector I has its own way of living and building, so the design has to start from there and not from a generic template.
OUR APPROACH
Renovation & Remodeling, the way we do it
Renovation is a completely different discipline from building new, and the catch here is that most studios treat it like a simpler version of the same thing, which it is not. When we take on a renovation, we are working inside an existing structure that has its own quirks, its own load-bearing walls, its own plumbing runs that nobody bothered to document, and often decades of decisions layered on top of each other. What we actually do is spend real time understanding what the house already is before we talk about what it could become, so that the work we propose is genuinely buildable and not just a pretty drawing that falls apart the moment a contractor opens a wall.
- 01Structural assessment before any finishes work, so surprises stay manageable and budgets hold
- 02Replanning room layouts within existing walls to improve flow without unnecessary demolition
- 03Upgrading kitchens and bathrooms fully, plumbing rerouting and all, not just surface finishes
- 04Coordinating civil, electrical, and carpentry trades so the site runs in the right sequence
IN SALT LAKE SECTOR I
Designing in Salt Lake Sector I
The homes here
The housing stock in Sector I is almost entirely established cooperative homes and low-rise residential blocks, many of them built by HIDCO-era standards with generous room sizes but layouts that were not conceived for open kitchens, home-office corners, or the kind of storage a family accumulates over three decades. What this means practically is that we spend a good amount of time in the planning stage reading the existing structure carefully, identifying which walls are load-bearing, and figuring out how to coax genuine liveability out of a floor plan that was never meant to be touched again.
What we plan for
Kolkata humidity is the single biggest material constraint we design around in Sector I, so finishes, joinery, and hardware all get selected with the monsoon in mind, and that shapes everything from the veneer we choose for shutters to how we detail the false ceiling edge. The leafy canopy here is lovely but it also means lower direct light in ground and first floor units, so we plan artificial lighting early and not as an afterthought. Cooperative society rules on structural changes, common-area access for material delivery near AK Block Market, and the relatively narrow internal lanes for large-vehicle access are all things we factor in before the first drawing is issued.
Our studio runs out of New Town, which is close enough that a site visit to Sector I is a quick run across the bypass, so we can be on the ground whenever something needs a decision rather than managing the job remotely. We have worked with cooperative housing constraints and Kolkata's specific climate enough times that none of the usual complications here catch us off guard, and at the end of the day that local working knowledge is what saves a renovation from going sideways mid-project.
HOW WE WORK
From first call to handover
Site & Specs
Assessment, measurements, technical evaluation
Concept & Sketching
Ideation and layout visuals
Design Development
Finalizing materials, lighting, furniture, and aesthetics
3D Visualization
Immersive previews for total clarity
Cost Proposal
Transparent breakdown of budget and deliverables
Material Sourcing
Selection of high-quality finishes and furniture
Project Supervision
Ensuring the outcome matches the vision
COMMON QUESTIONS
Renovation & Remodeling in Salt Lake Sector I
Basically we phase the work room by room wherever the layout allows, so one part of the house stays functional while the other is under construction. We have done this many times in Kolkata flats and it requires very tight scheduling with the contractors, which we manage directly from our end.
To be very honest, older Kolkata construction almost always has something unexpected once you open walls, whether it is undersized wiring, corroded pipes, or minor structural cracks. We build a contingency into the scope from the start and flag anything we find early so you can decide how to proceed rather than getting a shock mid-project.
This is basically the most common situation we encounter in Sector I blocks. We start by reading the original structural drawings if the society can provide them, and then we design around the constraint, whether that means a pass-through opening, a peninsular counter treatment, or a completely rethought kitchen zone that works with the wall rather than against it.
We ask for the society's bye-laws and any HIDCO-era building rules at the very start of the engagement, right before we begin concept drawings, so the design we propose is one that can actually be built. There is no point falling in love with a layout that the society will not approve, so we sort that out first.
Quite a bit, to be very honest. We treat lighting as a structural design decision in ground-floor Sector I units, not a finishing touch, which means we plan the ceiling zones, the reflection surfaces, and the artificial light layers together so the flat does not feel like a cave even on an overcast monsoon afternoon.
MORE IN SALT LAKE SECTOR I